Through hole tap (inch type)
TH 1.6 SERIES
- A chip mounter can be used for this
- A spacer can be fit on a PC board just by automatically loading it on the PC board and carrying out with reflow.
- It can be fit from the part face, soldering face, and both
- Tape-and-reel has an adsorption Please remove it by pushing it from the opposite side after reflow.
- The jig for removing adsorption films (Part: TH-JIG) is available.
- Material: Brass
- Finish: Tin plating over a nickel base
- Rated current: TH-1.6- □ -2-56 ……20A, TH-1.6- □ -4-40 ……30A, TH-1.6- □ -6-32 ……40A
- Tightening torque:
TH-1.6- □ -2-56……3kgf-cm(29.4N-cm)or less
TH-1.6- □ -4-40……5kgf-cm(49N-cm)or less(X-direction)
3kgf-cm(29.4N-cm)or less(Y-direction)
TH-1.6- □ -6-32……8kgf-cm(78.4N-cm)or less
● Adaptive printed board thickness: t1.6 or over
(There is no problem if it is used for other board thickness.)
● Please use the automatic mounter of automatic recognition type