TH-series

Through hole tap (inch type) for Surface Mounting 

TH SERIES                                                                                                                            

● A through hole changes to a threaded hole (M1.0, M1.2, M1.4, M1.6, M1.7, M2, M2.5, M2.6, or M3).
● Taping type has an adsorption film. Please remove by pushing it from the opposite side after reflow.
● The jig for removing adsorption films (Part No.: TH-JIG) is available.
● Material: Brass
● Finish: Tin plating over nickel base
● Rated current:
TH-0.8-M1.0……10A TH-1.6-M1.7……15A
TH-0.8-M1.2……12A TH-1.6-M2………20A
TH-0.8-M1.4……12A TH-1.6-M2.5、M2.6…20A
TH-1.6-M1.6……15A TH-1.6-M3………30A
● Tightening torque
TH-0.8-M1.0……0.3kgf-cm（2.94N-cm）or less
TH-0.8-M1.2……0.6kgf-cm（5.88N-cm）or less
TH-0.8-M1.4……1.0kgf-cm（9.8N-cm）or less
TH-1.6-M1.6……1.5kgf-cm（14.7N-cm）or less
TH-1.6-M1.7……1.5kgf-cm（14.7N-cm）or less
TH-1.6-M 2 …… 1.5kgf-cm（14.7N-cm）or less
TH-1.6-M2.5、M2.6……3kgf-cm（29.4N-cm）or less
TH-1.6-M3 …… 5kgf-cm（49N-cm）or less(X-direction)
3kgf-cm（29.4N-cm）or less(Y-direction)
● Adaptive printed board thickness: t1.6 or over (TH-1.6 series), t0.8 or over (TH-0.8 series)
(There is no problem if it is used for other board thickness.)
● Recommended metal mask thickness:150 μm to 200 μm